A new SERVICE is now AVAILABLE!! Check it

Software setup

STEP 1: Install mks firmware

Connect the power cable shown in (1) to the input voltage port shown in (1.1) (range from 12-24V, maximum current: 5A).
Connect the controller to the computer using the USB-A to USB-B cable shown in (2) to the USB-PC interface input shown in (2.1) and make sure the driver is enabled and defined by the computer (right-click on windows icon, choose Device manager, check the Port portion with its associated COM number) check the steps shown in (2.2).
The connection of the power and data cable is shown in (3).
Download the MKSLaserTool software setup by the following link:

Run the software, the window shown in (4) will open, click on MKS DLC32 download tool.
Load the firmware: click on the 3-dotted button, choose the downloaded firmware, apply the same settings as shown in (5) (make sure to choose the right COM number and the BAUD = 115200), and finally click Start.
When the installation of the firmware is done, unplug/replug the power of the controller.

(1)

(1.1)

(2)

(2.1)

(2.2)

(3)

(4)

(5)

Next step

Page updated

Google Sites

Report abuse